Inspect a Forklift
There are over 10,000 workplace injuries related to forklifts happen each year, based on OSHA and HRSDC reports. Many of these accidents are caused by operator error. Lack of appropriate equipment inspection and maintenance results in numerous others. Forklift operation and maintenance is not only the reason for personal injuries, but also of property damage. Forklifts can damage building structures, overhead pipes and sprinklers, and other equipment when wrongly used. The following day by day check ups must be done in order to lessen the likelihood of forklift mishaps.
Before inspecting different fluid levels turn the engine off. Check these fluids: fuel, engine oil, hydraulic oil, coolant and brake fluid. The tires also have to be checked for signs of wear and tear. Check the air pressure in the tires. Check the forks' condition. The load backrest must be attached firmly. Do a visual check of the top-clip retaining heel and pin. Next perform an inspection of the mast chains, hydraulic hoses, cables and stops. Ensure that both the finger and overhead guards are firmly attached.
LP forklifts have propane tanks that have to be inspected for signs of corrosion, damage or rust. Test the battery's charge and electrolyte levels. All belts must be inspected for wear. Check to make certain the owner's handbook is kept on-board the forklift inside a storage compartment. Test the seat belt to make certain the latches are secure. Test the hood latch to ensure it is functioning as it should.
To make sure there are no unusual engine sounds, start the engine up and listen for any irregularities. If there are, investigate at once. Check the accelerator and the steering controls. The parking break and the service break must be functioning properly.
The tilt control and drive control must be checked to guarantee proper functioning in both reverse and forward. Test the functioning of the lowering control and hoist, and the attachment control. Test the lights and horn. Afterward check the wipers, heater and defroster to make certain they are working well. Inspect each and every gauge to find out that it is reading within functional limits.