Change a Propane Tank
Forklifts powered by propane are common inside warehouse environments. These forklifts have a propane mount situated at the rear of the driver. These tanks have to be replaced periodically since they have limited lifespans. Drivers of forklifts must always utilize care when handling propane tanks. Compressed gases are dangerous, especially since the gas is flammable. Always utilize caution when removing and replacing propane tank to prevent injury.
1 To change a propane tank, first stop the forklift and leave the engine running, and turn the valve on the tank off. Let the forklift run until the engine dies. This process burns the gas off in the transfer hose which connects the tank and the engine. Before taking the second steps, put on the correct safety equipment, like for example insulated gloves made of either neoprene or leather. It is essential for you to protect your skin from contact with the compressed gas, that is extremely cold.
2 Disconnect the hose from the tank and take the holding straps off to remove the tank. When putting in a new tank, reattach the holding straps and reattach the hose at the valve of the tank by tightening the nut.
3 You could check for leaks by applying soapy water to the valve and opening it slightly. Leaking gas will cause bubbles to froth around the value. If this occurs, check the connection hose at the nut and the valve area. Re-tighten the connecting nut if you detect any leaks in the valve area, and then do the leak checking process over again. Persistent leaks mean that both the connecting hose and nut should be replaced. Nevertheless, if replacing the hose and nut still does not stop the leak, the tank must be replaced.
4 Open the valve all the way to allow the gas to fill the connecting hose. After that you can start the lift truck and continue operating.