Most of the time, companies would spend lots of money to purchase their lift trucks. It is essential, therefore to take good care of your machinery to protect your investment into the long run. It is really a great idea to know the procedures that are carried out during taking care of and maintaining this machinery.
Among the best ways to tell how good the engine is running is by starting the lift truck up and listening closely to see how it runs. For instance, if there are any knocks or misses, the equipment is defective and this should raise several issues. Also listen closely for any squealing noise that come from the belts as these sounds would provide you with a wealth of information.
When carrying out maintenance, several of the main parts you would need to pay attention to consist of the horn, safety warning devices, the overhead guard, the lights and the gauges. Any burnt out light bulbs or faulty components should be replaced as soon as they are noticed. It is also imperative to check the wiring.
The battery compartment terminals should be cleaned after the above parts have been inspected carefully. If the terminals are not clean, be sure to clean them well. Each cell of the battery should be checked so as to ensure the fill level is topped up to the regulated amount.
The next step is to drain all of the oil out of the machine and after that change the filters. The transmission filter, fuel filters and the hydraulic filter must be replaced regularly. Before fitting them, be sure to write the date on the new filters by utilizing a permanent marker in order to keep track.
When the oil change has been carried out and new filters have been fitted, visually check the drive axle from beneath the equipment. Be sure to grease the axle if there is any grease fitting. Check the engine belts for any frays or cracks. If you find any, fix the issue accordingly. Next, check each and every other part of the machinery including the wheels. If any kind of fault or concern is detected, be certain to address it immediately in order to make sure the machinery is working at its safest and optimum levels.